Page 7
Chapter 2 describes the installation of the DIP-1/115
control.
2.1 UNPACKING
Unpack the DIP-1/115 from its box and inspect contents for
damage. Should the contents appear to be damaged,
contact your local distributor for return material procedures.
The package should contain the following standard items:
•
1 DIP-1/115 control.
•
1 installed outside temperature probe (2004-1K).
•
3 cable fasteners or fuse.
•
1 Installation/User’s manual.
2.2 MOUNTING
Use a screwdriver to remove the faceplate and the plate of
the power compartment.
The manufacturer recommends that the installation
instructions which follow be adhered to as closely as
possible, and all work be performed by a certified
electrician. Failure to do so may void the warranty!
To limit the unit’s exposure to noxious gases install the
unit in a hallway.
Make certain that the unit is mounted right side up with
the cable entry holes facing down.
The DIP-1/115 will operate in a temperature range of
32ºF - 120ºF (0ºC - 50ºC).
Install the DIP-1/115 not longer the 2 meters from each
ECS.
The enclosure is watertight, but not splash proof or
immersion proof. DO NOT WATER the control. Cover the
control carefully with plastic when cleaning the room.
*It is prohibited to use overhead cables outside the
building.
Mounting hardware is not included with the unit.
CHAPTER 2 - INSTALLATION
www.monitrol.com
