Varec 2500, Installation And Operation Manual

Page: 31 / 124

Varec, Inc. 21
Chapter 3
Installation
This chapter gives instructions for the various types of installations based on the order code
options for the 2500 ATG.
Note Before installing your 2500 ATG, read and review all see the “Safety Precautions”
section of the preface to this document. Continuing with installation according to the
instructions in this manual presumes you have reviewed these safety precautions.
Note Refer to Section "Identifying Your Installation Type" on page 11 before proceeding.
Installation Schematics
Figure 1: Cone Roof Tank
1-1/2 Inch NPT union
recommended
C
17.00
[432]
7
9
3
4
2
14.50
[368]
ø
Maximum
36.00
[914]
16.00
[406]
Minimum
.25
[6]
6
Tank
roof
24.00
[610]
Suggested
8
C
Convenient
eye level
Grade
1
6.00 [152]
View C-C
Pipe support bracket detail
Layout for pipe supports
spaced approximately at
10 foot [3 meter] intervals
8.00
[203]
.25
[6]
5
Typical
.25
[6]
Typical
4.50
[114]
4.50
[114]
1. Gaugehead
2. Float
3. Tape
4. Tape/Cable fastener
5. Pipe Support Bracket
6. Top Anchor
7. Bottom Anchor
8. Sheave elbow
9. Float Guide Cable
Unless otherwise noted
dimensions in inches (millimeters).
All welding by customer.
Note Installation hatch not shown.
Varec recommends installing a
installation hatch.
1-1/2 inch NPT
coupling
furnished
by customer
17.00
[432]
8.50
[216]
1-1/2 Inch NPT coupling
furnished by customer
2x Ø1.75 [44] hole
1-1/2 Inch pipe and fittings
furnished by customer