Varec 2500, Installation And Operation Manual

Page: 29 / 124

Varec, Inc. 19
Table 9: External Floating Roof Tank: No Floatwell — Installation Checklist
Interface Service
Order Code T51, T52, T53, T54
Installation parts supplied include:
•
90° Elbow assembly (x2)
•
Gauge 'U' bolt kit
•
Guide Wire bottom anchor
•
Guide Wires
•
Support bracket (x6)
•
gauge head and tape
•
Interface float
•
Guide Wire top anchors (x2)
•
Tape connectors
Figure 13: Interface Service
Installation Checklist
When installing a 2500 ATG system on a cone roof tank, complete each installation step below.
Check off a step when it is complete. Refer to Section “Installation Schematics” on page 21 for
overall dimensions.
9 Section “Initial Lubrication” on page 42
10 Section “Install a Transmitter and Replace all Covers” on page 42
11 Section “Initial Operation” on page 43
Step Description Complete
Step Description Complete
1 Section “Tank Roof Entry - Cone Roof Tank” on page 23
2 Section “Installing Anchors and Guide Wires” on page 25
3 Section “Installing Support Brackets & Pipework” on page 27
4 Section “Installing a Gauge Head at Grade Level” on page 28
5 Section “Float installation on an Out-of-Service Tank” on page 30
6 Section “Connecting the Tape to the Float” on page 30
7 Section “Feeding the Tape to a Gauge Head Located at Grade Level”
on page 34
8 Section “Install Tape in the Gauge Head” on page 35
9 Section “Reset the Counter” on page 40
10 Section “Calibrate the Counter” on page 41