Side Cover
Side Cover - Removal
1. Remove the connector cover from the side cover. Lift the
tab of the snap latch (
A
, Figure 21) and rotate the cover
away from the engine to remove.
21
2. Remove the DLC (
A
, Figure 22) and equipment
connector (
B
) from the wire harness clips.
22
3. Remove the upper operator panel to side cover fastener
(
A
, Figure 23).
23
4. Remove the two side cover to mounting bracket
fasteners (
C-D
5. Remove the side cover from the engine and set aside.
Side Cover - Installation
1. Install the side cover onto the mounting bracket and
rear of operator panel. Make sure that the side cover
alignment tab is located BEHIND the operator panel.
2. Start by hand the two side cover to mounting bracket
fasteners (
C-D
50 lb-in
(5.6 Nm).
3. Start by hand the operator panel to side cover fastener
(
A
, Figure 23). Tighten to
50 lb-in
(5.6 Nm).
4. Secure the DLC to the side cover wire harness clip (
A
,
5. Secure the equipment connector to the side cover wire
harness clip (
B
, Figure 22).
NOTE:
Depending on your engine's trim, the oil level sensor
wire is retained by the equipment connector harness clip.
6. Install the connector over by inserting the cover
tabs into the two slots on the side cover. Rotate the
connector cover toward the side cover until the snap
latch (
A
, Figure 21) is engaged and "clicks" into place.
79
Not for
Reproduction
Summary of Contents for 25E300
