Vanguard 25E300, Repair Manual

Page: 76 / 104

6. Remove the rear air cleaner mounting fastener ( A , Figure
17).
17
7. Remove the two air cleaner base to throttle body
fasteners ( B , Figure 15).
8. Remove the air cleaner assembly and gasket from the
throttle body. Discard old gasket.
Air Cleaner Assembly - Low Mount - Installation
1. Prior to assembly and installation, make sure that all
mating and gasket surfaces are clean, dry and free from
contamination.
2. Install the new air cleaner base gasket onto the
alignment pins of the flange. Make sure the orientation of
the gasket matches the profile of the air cleaner flange.
See Figure .
18
3. Install the air cleaner assembly onto the throttle body
mounting studs.
4. Start by hand the two air cleaner to throttle body
fasteners ( B , Figure 15). Tighten to 40 lb-in (4.5 Nm).
5. Start by hand the lower support bracket fastener ( A ,
Figure 16). Tighten to 95 lb-in (10.7 Nm).
6. Start by hand the rear air cleaner mounting fastener ( A ,
Figure 17). Tighten to 50 lb-in (5.6 Nm).
7. Install the valve cover breather hose onto the air cleaner
port ( A , Figure 15).
8. If removed, install the air filter into the air cleaner base.
9. Install the air cleaner cover. Engage the cover retaining
clips to secure.
77
Not for
Reproduction