2. Remove the DLC from the wire harness clip (
A
, Figure
2
3. Remove the DLC protective cap. Pull out the locking tab
(
A
, Figure 3) and press the connector tab while pulling
the protective cap (
B
) away from the DLC.
3
NOTE:
Make sure to reinstall the DLC protective cap when
diagnostic procedures are concluded.
Using the Diagnostic Tool and Software to Read/
Clear DTCs
1. Open the Briggs & Stratton Diagnostic Tool Application
by selecting the icon on the desktop.
2. After entering the User Name and Password, click Log
In.
NOTE:
If this is your first time using the Diagnostic Tool and
Software, refer to the
Briggs & Stratton EFI Diagnostic Tool
Software User Manual
for installation and setup instructions.
3. Obtain Briggs & Stratton Diagnostic Tool (Part No.
19636) with USB and Interface cables.
4. Connect one end of the USB cable to the Diagnostic Tool
and the other end to the USB port on the laptop.
5. Connect one end of the Interface cable to the Diagnostic
Tool and the other end to the DLC on the EFI harness.
13
Not for
Reproduction
Summary of Contents for 25E300
