AIR N ARC
®
300 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 6: MAINTENANCE
090034-OP_r0
PAGE - 99
5. At this point the belt will need to be checked
for proper tension. Consult
Section 6.6.15.3
on how to re-tension the generator
serpentine belt, and
Section 6.6.15.1
to re-
tension the compressor serpentine belt.
6.7 SERVICING THE SYSTEM FUSES
AND CIRCUIT BREAKERS
Consult
Figure 6-20
for the location of the DC welder
generator fuse, the location of the Power System fuses,
and the location of the motor fuse.
6.8 STORAGE AND INTERMITTENT
USE
6.8.1 INTERMITTENT USE
If the unit is not used very regularly always treat the fuel
with a fuel stabilizer.
Check all belts and hoses for signs of deterioration such
as visible surface cracks, stiffness or discoloration.
6.8.2 LONG TERM STORAGE
Disconnect the battery cable that is connected to the
positive (+) side of the battery.
System Component or
Part Group Task
Manual
Section
Location
Storage and Intermittent Use
6.8
page 99
Intermittent Use
6.8.1
page 99
Long-term Storage
6.8.2
page 99
NOTE
Compressor belt goes on the outer track
of the motor sheave; generator belt goes
on the inner track.
CAUTION
Parts can wear over time. Do not operate
with worn equipment; replace as needed.
DANGER
Fuses will need to be replaced if they are
blown when tripped. When changing any
fuse, or dealing directly with any
function of the electrical system
maintenance, always be aware of the
safety warnings given in
Section 1,
Safety
.
NOTE
Replacement fuses can sometimes be
found at local vendor carriers, such as
automobile supply stores, hardware
stores, etc.
