Van der Ende Groep. · Aartsdijkweg 23, 2676 LE, Maasdijk · Telefoon 0174 515050
IBAN NL71 RABO 0340341610 · KvK Den Haag 27230471 · Btw-nummer NL8000.78.378.B01 · [email protected] · www.vanderendegroep.nl
Pagina 9 van 16
2
Description
This chapter contains an explanatory description of the machine, which is the background information
that is required to correctly and safely use the machine.
2.1
General
The rotation of the mixer shaft and the mixing disc sets the liquid in the reservoir in motion. The
mixing disc takes in the liquid from above and then sends the liquid downwards and to the side via
the channels in the mixing disc. In the disc there are 3 channels towards the bottom of the disc and 3
channels directly to the side of the mixing disc. This causes the liquid to move as shown in Figure 3.
The standard direction of rotation of the mixing disc is clockwise (viewed from above).
Figure 3: Position of the mixing disc
2.2
Operating principle
The Enmix Light construction comprises a motor and an extended shaft to which a mixing disc has
been attached. The shaft can be customised to fit every fertilizer bin or other container of liquid
substances shorter or shallower than 140 cm. The mixing disc must be mounted at least 10 cm from
the bottom and must be able to rotate freely while submerged in the liquid.
The material used is predominantly stainless steel type 316 and POM black. When working with low
pH values (under pH4) or with other stronger chemicals ensure beforehand whether the material is
sufficiently resistant to these chemicals.
The shaft is not supported. Because the mixing disc propels the liquid in two directions (downwards
and sideways) and from the centre (from the top), the shaft remains balanced.
It is recommended to check the mixing disc once a month to ensure that it is not clogged.
2.3
Transport and storage
The Enmix Light is transported and should be stored in special packaging. The Enmix is transported as
a complete product, the shaft length should be adjusted at the end-user by an approved installer.
When storing the Enmix Light, care must be taken not to allow the mixer shaft and, where
appropriate, the shaft guide to bend.
