Van der Ende Groep. · Aartsdijkweg 23, 2676 LE, Maasdijk · Telefoon 0174 515050
IBAN NL71 RABO 0340341610 · KvK Den Haag 27230471 · Btw-nummer NL8000.78.378.B01 · [email protected] · www.vanderendegroep.nl
Pagina 13 van 16
4.5
Installation
−
Select a suitable location for the Enmix Light:
o
Ensure the mixing disc can rotate freely.
o
Ensure the mixing disc r/- 100 mm from the bottom of fluid reservoir
▪
see Figure 3
o
Ensure that the mixing disc is submerged during standard operation.
o
Ensure there is sufficient space around the Enmix Light.
o
Ensure there is a socket outlet within a maximum range of 2 metres from the Enmix Light.
o
Ensure the Enmix Light is within view of the socket outlet.
−
Prepare for installation:
o
Consider where to place the Enmix Light.
o
Make the necessary arrangements to mount the Enmix Light onto the bin or container.
▪
Use the pre-drilled holes in the mounting plate to mount the Enmix Light.
o
In a round bin or container, the water sometimes turns and swirls in one direction instead
of mixing. In consultation with the manufacturer, place a dividing plate in the bin or
container to prevent this from happening or position the Enmix Light away from the
centre.
o
Ensure the Enmix Light can be mounted safely onto the bin or container.
▪
Request assistance and use practical aids such as a stepladder or a footstool.
−
Mount the Enmix Light onto the bin or container.
−
Make sure the mixer is fitted with a safety guard and poses no danger to people!
o
Use a cover or grid or any other appropriate guard.
−
Assemble the mixing disc following Figure 3 and Figure 4. If the assembly of the mixing disc is
done in the wrong way, the fluid can be sprayed upwards. This could create dangerous situations.
4.6
Connecting / start-up
−
Check that the Enmix Light is securely mounted.
−
Check that the motor and mixing disc are firmly attached to the mounting plate.
−
Check that the shaft can rotate freely.
−
Check that the mixing disc can rotate freely.
o
Make sure there are no obstacles in the way of the mixing disc.
−
Make sure that the mixing disc is mounted at least 100 mm from the bottom of the bin or
container.
−
Fill the bin or container with liquid up to at least 100 mm above the mixing disc.
−
Make sure the mixer is has a safety guard and poses no danger to people!
−
Insert the plug in the socket.
o
The Enmix must be within view of the socket outlet.
o
The socket outlet must have an earth connection.
o
A switched socket outlet is highly recommended.
−
Check the rotational direction. The standard direction, viewed from above, is clockwise.
Note: In most cases, it is not necessary to continue mixing. Operating the Enmix Light with a timer
and/or low water circuit is recommended. This will prevent unnecessary turning and will significantly
increase the lifespan of the machine.
