27
13.5
To Remove The Gas Tap/F.S.D & Solenoid Assembly.
13.5.1
Remove the burner unit - See section 13.4.
13.5.2
Disconnect the electrode lead from tab underneath the electrode.
13.5.3
Undo the thermocouple nut at the gas tap.
13.5.4
Disconnect the inlet pipe at the solenoid junction.
13.5.5
Disconnect the main burner pipe at the tap end.
13.5.6
To gain access to the pilot pipe connection, detach the fan switch
bracket from the burner control bracket by removing two screws (see
figure 31).
13.5.7
Disconnect the pilot pipe at the tap end.
13.5.8
Pull off the control knob.
13.5.9
Remove the gas tap fixing nut.
13.5.10
Disconnect the two burner wiring loom leads from the solenoid unit.
13.5.11
Disconnect the earth lead from the solenoid unit.
13.5.12
Pull the tap & solenoid unit clear.
13.5.13
To separate the tap from the solenoid, detach the solenoid unit at the
gas tap end
13.5.14
Replace in the reverse order.
13.6
To Remove The Piezo Generator
13.6.1
Remove the gas tap & solenoid unit as sections 13.5.1 to 13.5.12.
13.6.2
Make sure that the tap is in the off position.
13.6.3
Remove the circlip holding the piezo unit to the tap. Remove the piezo
unit.
13.6.4
Replace in the reverse order.
13.7
To Remove The Main Burner Injector
13.7.1
Detach the burner unit from the convection box as section 13.4.
13.7.2
Disconnect the main burner pipe from the injector. If necessary, loosen
the pipe at the gas tap end to swing the pipe clear of the injector.
13.7.3
Unscrew the injector from the support bracket.
13.7.4
Refit in the reverse order. Make sure that no leads are trapped.
13.8
To Remove an “On” or “Off” Fan Switch
13.8.1
Detach the fan switch bracket from the burner control bracket by
removing two screws (see figure 31). Carefully pull clear of the burner unit.
13.8.2
Detach the two leads from the switch which is to be removed.
13.8.3
Press in the plastic spring grips at the ends of the switch and pull the
switch clear of the bracket.
13.8.4
Replace in the reverse order. Make sure the correct leads go to each
switch (see wiring diagram figure 15). Make sure that no leads are trapped.
Figure 31 Fan switch fixings
