30
Fuel Beds
Installation
Driftwood Kit and Liners 530DWK
Unpack each piece of the ceramic driftwood set
carefully to avoid damages. The set contains:
• Metal platform
• Left and right side reversible ceramic panels
• Rear panel support
• Rear
fl
uted panel
• 5 driftwood logs
• 4 ceramic pebbles
580RGL Re
fl
ective Glass Liner Set.
To install the
580RGL, see the installation instructions provided with
the kit.
Install liners
1. Remove the rear
panel support inside
the
fi
rebox (3 screws).
2. Replace with the
rear panel support
provided with the
530DWK kit and
fi
x it
(3 screws).
If installing the
567FGP Top Grille
(sold separately),
fi
t it
now.
See instructions
supplied with the
grille.
3. Place the rear panel
on the rear support
as indicated. Hold in
place and go to next
step.
4. Place the left and
then the right panels in the
fi
rebox showing the
black
fl
uted sides.
Install platform, driftwood logs and pebbles
1. Place the protrusion at the back of the base log on
the ledge of the rear panel support as far back as it
will go. Then pull the log evenly towards the front
until it rests against the burner supports.
2. Place the metal platform and centre it over the
burner and around the base log with the pegs on
the top. The front of the platform must rest on the
edge of the
fi
rebox. The right end rests of the base
log.
