Valor Inspire L, Installer And Owner Manual, Page: 6 / 61

10. LED CHECK 24
10.1 Fitting the transformers male DC jack connector into convection box 24
10.2 Connecting the male and female DC jack into the LED circuit 24
10.3 Checking the LED operation 24
11. FITTING THE WALL LINERS 25
11.1 Fitting the rear wall liner 25
11.2 Fitting the Glass liners spacer support. 25
11.3 Fitting the side wall liners. 25
12. BURNER AND SUPPLY PIPE INSTALLATION 26
12.1 Burner installation. 26
12.2 Supply pipe installation. 26
12.3 Burner checks - FS model 26
- 12.3.1 Lighting the fire 27
- 12.3.2 Adjusting flame height 27
- 12.3.3 Turning off 27
12.4 LED fuel effect checks. 27
- 12.4.1 Lighting the LED fuel effect 27
- 12.4.3 Turning off 27
12.5 Burner checks - RC model 28
- 12.5.1 Lighting the fire 28
- 12.5.2 Adjusting flame height 28
- 12.5.3 Turning off 28
12.6 Check inlet pressure. 29
13. REASSEMBLE OF FIRE & LOG SET LAYOUT 29- 31
13.1 Fitting the burner unit into convector box 29
13.2 Fitting the top tray onto the burner unit 29
13.3 Install the log set 29
- 13.3.1 Placement of the 4 small logs 29
- 13.3.2 Placement of Clear Glass Pebbles 30
- 13.3.3 Placement of Grey Chips and Natural vermiculite flakes 30
- 13.3.4 Placement of the 3 large logs 31
13.4 Fitting the top tray onto the burner unit 31
13.5 Install the log set 31
14. FULL OPERATING CHECKS 32
14.1 Check the burner operation. 32
14.2 Check for spillage. 32
14.3 Flame supervision and spillage monitoring system. 32 - 33
©
GDC Group Ltd. SEPT 2018
Page 6
Continued on next page
CONTENTS (Continued)
Section Page
INSTALLER GUIDE