Page 35
©
GDC Group Ltd. SEPT 2018
19.1 To remove the visual baffle.
1.
Remove the visual baffle held in place by two magnets,
hold securely and carefully slide out the decorative trim and
place carefully to one side.
3.
Replace in the reverse order.
19.2 To remove the window door panel.
1.
Complete section 19.1
2.
Remove the glass door, by unscrewing by hand the single
M5 knurled screw in an anti clockwise direction located just
under the center base of the door frame. Keep this screw
save as it will be needed later. Carefully pully out at the base
then lift up and off the door and place carefully to one side.
4.
Replace in the reverse order.
19.3 To remove the fuel effect.
1.
Complete sections 19.1 - 19.2
2.
Remove the fuel effect in the reverse order to that shown for fitting in Section 14.
To gather the smaller decorative items pebbles/chips/flakes a clean storage basin is
recommended. The ceramic fuel effect may cause staining / discolouration to
decorative surfaces. It is therefore advisable to protect decorative surfaces.
3.
Replace all in the reverse order following the original steps in Section 14.
19.4 To remove the top tray.
1. Complete sections 19.1 - 19.3
2. Unscrew and lift out the Top tray and carefully place to one
side.
3. Replace in reverse order.
19.5 To remove the burner assembly.
1.
Complete section 19.1 - 19.4
2.
Isolate the gas supply at the inlet isolating ‘T’ connector.
3.
Support the inlet ‘T’ connector to avoid straining the
pipework and disconnect the appliance from the inlet ‘T’
connector.
4.
Unscrew the burner tray from the convection box by
removing four locating screws.
5.
Slide the burner tray unit clear of the convector box, taking
care not to catch any of the wires to the Ignition unit on the
LHS off the magnet for the Visual baffle.
6.
Replace in the reverse order.
INSTALLER GUIDE