©
GDC Group Ltd. SEPT 2018
Page 46
The control required 3 AA size alkaline batteries to be
inserted under the battery compartment cover. The
orientation of these is shown moulded into the battery
compartment and as shown below.
After fitting the batteries and replacing the cover the fire
can now operate.
Slide the valve control On/Off switch to the right to the On position (I symbol).
2b - To start the fire manually
(without the use of the Remote control handset),
press the power button and hold for 1 second then release. The burner will within
around 1 to 10 seconds, adjust to the maximum power setting. The power of the
burner can be adjusted up and down by pressing the – and + buttons.
2c - To turn off the fire
, press the power button again and the burner will stop.
3. Remote handset (401RC model)
3a - Lighting the gas fire & operation
NOTE:
Ensure the power isolator switch on the front corner of
Fire Control is in the on position.
To activate the handset
- Grasp around the handset to unlock
its functions. The green unlock light will illuminate to show
when the handset is unlocked and ready to accept commands.
(N.B. Keep a grip of handset to keep it unlocked, to continue to
operate the command buttons.)
Power button
–
To turn on the fire
, with one hand grasp
around the rear of both sides of the button area control. The
green unlock light will illuminate. Keep the handset held to
keep the control unlocked, to enable operation of the buttons.
Then with the other hand touch and hold a finger on the power
button for about 3 seconds. (A short beep and a flash of the
unlock light will happen upon touching.) When the word “pilot”
OWNER GUIDE