30
Co-Linear Vent Installations
• The chimney and fi replace opening sizes are shown in
Dimensions
and
Location
sections of this manual.
• Place the appliance (fi tted with the co-linear adapter)
near the fi replace opening but allow space for
manipulating the chimney liners on to the appliance.
• Drop the 3-inch diameter fl exible liners into the
chimney from outside.
• Fit the liners to the co-linear adapter paying attention to
inlet and exhaust and move the appliance to its proper
position. Be aware of the minimum liner bend radius
and maximum liner horizontal run as indicated at right.
• Fit the termination kit and fl ashing to the exterior of the
chimney.
Secure the appliance to the fl oor or wall if necessary.
Rear or Top Outlet Conversion to Co-Linear
Liners using Valor 556CLA Co-Linear Adapter.
(Generic co-axial to co-linear adapter boxes may also be used as
an alternate to the 556CLA).
Only for use when retro
fi
tting a solid-fuel burning
fi
replace and chimney.
The appliance must not be connected to a chimney fl ue serving a separate
solid-fuel burning appliance.
Requires 556CLA Co-Axial to Co-Linear Appliance Adapter (or, alternatively, a
generic adapter), two lengths of 3-inch diameter fl exible chimney liner, co-linear
termination kit and fl ashing and either high wind vertical vent terminal cap or a
low profi le vertical termination.
Zero Clearance stand-o
ff
s and shields supplied
with the heater are not required for this application
.
Flashing
2 x 3”
liners
3” min.
bend radius
Co-linear
adapter
2 x 3”
liners
18” max.
horizontal run
Co-linear
adapter
534
engine
Max.
40’
Approved co-linear
termination or approved
co-linear adapter
and approved
co-axial
termination
Co-Linear Venting
Co-Axial to Co-Linear Adapter
(alternate to 556CLA)
10”
10”
3” Inlet & Exhaust
Collars
7-5/8” dia.
collar
556CLA
2 x 3” Liners
26-3/4”
14”
556CLA
2 x 3” Liners
26-3/4”
14”
556CLA on
Rear Outlet
556CLA on
Top Outlet
Alternate to 559CLT/559FSK Conversion
559FSK Flashing Kit
559CLT Co-Linear Terminal
Co-Linear installation into existing F/P
556CLA Kit
Terminal Cap
Co-Linear to Co-
Axial Adapter
Flashing
QUALIFIED
INSTALLER
Summary of Contents for HORIZON 534JN
Page 56: ......
