Valor HORIZON 534JN, Installation & Owner'S Manual

Page: 11 / 58

11
Using the Remote Control
LOW BATTERY INDICATION
AUTOMATIC SHUT OFF
6:00 am
P1
Start time
8:00 am
P1
End time
4:00 pm
P2
Start time
10:00 pm
P2
Start time
6:00 am
P1
Start time
Set temp 74 Ő F Set temp 40 Ő F Set temp 74 Ő F
Set temp 40 Ő F
Automatic Turn Down
6 Hour no Motor Movement
Manual Mode/Temperature/Timer Mode: The valve will
turn to pilot ȵ ame if there is no change in ȵ ame height
for a 6 hour period. In Temperature/Timer Mode if the
ambient room temperature changes, the ȵ ame height
will adjust automatically to maintain set temperature,
and the ȴ re will continue to function normally. The
valve will turn to pilot ȵ ame if the set temperature and
the ambient room temperature remain the same over a
6 hour period.
Automatic Shut-O
΍
Low Batteries Receiver. With low battery power
in the battery holder the system shuts o
΍
the ȴ re
completely. This does not apply when the power supply
is interrupted.
On-Demand Pilot. This green feature eliminates
gas energy consumption during extended appliance
inactivity. When the appliance is inactive for 5 days
the system automatically extinguishes the pilot. This
feature helps the consumer realize cost bene ȴ ts by
automatically eliminating energy consumption during
non-heating months and limited use.
Timer Programming Example (default temperatures shown)
Ʉ
Caution
DO NOT USE a screwdriver or other metallic
object to remove batteries from holder. This
could cause a short-circuit.
Low Battery Indication
Remote handset: The battery icon will show
when the battery needs to be replaced. Replace with
one 9 V alkaline battery.
Remote battery holder: Frequent ‘beeps’ for 3 seconds
when the valve motor turns indicate the batteries
need to be replaced. Replace with four 1.5 V alkaline
batteries.
Handset / Receiver Match
The remote control handset and receiver are
programmed to function together. In case of a
replacement of the handset or the receiver, you will
need to reset the receiver to allow them to function
together. Contact your dealer for details.
Setting P2 ON and OFF times.
Repeat same steps as Setting P1 ON and OFF times.
When all settings are complete, press to save them.
OWNER’S
INFORMATION