INSTALLER GUIDE
Page 31
©
Baxi Heating U.K. Limited 2008.
15.2
Fitting the fascia.
1.
At the upper right side of the
fascia is a blanking plate. Unscrew
and remove the blanking plate as it
is not required.
2.
Supplied with the fire is a self
adhesive control position label. Peel
the backing from the label and place
as in figure 29.
3.
Place the fascia against the
fireplace front surface so that the two
retaining plates at the back of the
fascia are above the two upper
retaining brackets at the top of the
convection box. Lower the fascia
making sure that the rear retaining
plates locate fully into the retaining
brackets on the convection box (See
figure 29). If the inlet pipe runs along
the front of the fireplace, the bottom
of the fascia will have to be swung
forwards to clear the pipe while
lowering the casting.
4.
Secure the bottom of the fascia using the two
machine screws and washers supplied (See figure
30).
15.3
Fitting the ash pan.
1.
Place the ash pan in place.
Figure 30. fascia fixing (Fascia
may differ from that shown).
Figure 29. Fascia location (Fascia may differ
from that shown).