16.2 To remove or clean the window unit.
-
Remove the fascia (See section 17.1).
-
Unscrew and remove the three spring-loaded window-
fixing screws and bushes from the base of the window
frame (See figure 48).
-
Gently swing the base of the window frame forward
while lifting the frame upward. The window should lift
clear of the fire. Put the window in a safe place away
from your immediate work area.
-
Any stains on the glass can be removed with a non-
abrasive cleaner such as a ceramic hob cleaner. Never
use abrasive cleaners. Clean the window carefully in
accordance with the instructions supplied with the
cleaner.
-
Replace the window making sure that the seal around
the frame is not damaged or misplaced. Locate the
channel at the top of the window over the top of the
firebox opening.
-
Refit the three spring-loaded screws and bushes. The wide part of the bushes
should be against the window frame. Tighten sufficiently to seal to the firebox.
-
Replace the fascia and castings.
16.3 To remove the ceramic fuel effect and rear wall.
-
Remove the fascia (See section 17.1).
-
Remove the window unit (See section 17.2)
-
Lift out the ceramic fuel effect.
-
Remove the rear wall by carefully sliding it upwards to clear the retaining channel
and then swinging the top slightly forward.
16.4 To replace the ceramic fuel effect.
-
The fuel effect should be replaced as in section 11 (Coal) or 12 (Pebble). If
replacing the ceramic fuel effect, where a new guide is supplied, follow the installer
and owner guide supplied with the replacement fuel effect.
Page 37
©
GDC Group Ltd. 2014
INSTALLER GUIDE
Figure 48. Window fixing
