46
Installation
CAUTION
Do not run the switch wire over the top of the
fi rebox.
Route the wire so it does not contact the
fi rebox.
Install Remote Battery and Wall Switch Kit
RBWSK (required)
The Remote Battery and Wall Switch Kit is provided
with this appliance. It must be connected to the
receiver in the fi replace.
Please note that the
batteries cannot be
inserted into the receiver inside the
appliance
. They will overheat and possibly
leak and cause the system to stop functionning.
Material required
• 4 AA 1.5V alkaline batteries supplied with the engine
• Remote Battery and Wall Switch Kit, which contains:
◊ 1 Wall Switch
◊ 2 Screws
◊ 1 Battery Holder
◊ 1 Plate with magnets
◊ 1 Battery Cover assembly
◊ 1 Harness assembly - 35 ft
◊ 1 Junction Box
◊ 1 Cover plate and Screws
◊ 1 Cable tie
Installation
The receiver is located behind the appliance’s front
panel, at the right of the control valve. It is maintained
in position with
Velcro
bands.
1. From the front of the appliance through the access
panel, grab the wire harness threaded from the
back and bring it towards the receiver at the front
of the appliance.
2. Pull out the receiver from its location to connect the
wiring harness power connector to receiver’s jack.
3. Connect the harness’ white connector to the
auxillary 5-pin junction on the receiver.
4. Run the harness assembly to the mounted position
of the junction box, securing the harness to the
framing using insulated staples (not supplied).
5. Feed the harness assembly through a restrain on
the rear of the junction box, feeding through until
the harness sheath is pinched by the retainer and
ensuring suffi cent length to make the connection to
the rear of the switch and battery holder.
6. Secure the junction box to the mounting surface
using appropriate fasteners (not supplied).
QUALIFIED
INSTALLER
Summary of Contents for 2200JN
Page 74: ......
