INSTALLER GUIDE
Page 17
10
. Inspect the installation of the convection box against the fireplace surround. If the
convection box is aligned squarely and the sealing is satisfactory, fully tighten the cable
retainers.
11
. If the convection box is not correctly aligned, release the tension on the cables by
slackening the screws and turning the hexagonal adjusters fully anticlockwise. The
convection box should then automatically realign itself. Pull each cable taut again and
push the cable retainers back against the “V” brackets. Again, tighten the screws in the
retainers and apply tension to the cables by turning the hexagonal adjusters clockwise as
far as possible.
12
. Keep the free length of the inside the convection box so that they are available to
allow easy removal and refitting of the appliance during subsequent service calls
. Do not
cut off the free lengths of cable
.
8.3
Sealing Floor Front - All installations
Using the floor sealing tape supplied, seal the bottom of the
convection box to the fireplace and hearth floor - See figure
9.
Make sure that the whole length of the front edge of the
convection box is fully sealed.
Figure 9 Floor sealing
