- 20 -
18 Flexible hose
19 Head tilt knobs
20 Back protection.
21 Dust extraction connection
22 Dust extraction hose
INSTALLATION
IMPORTANT! The manufacturer is not liable
for any direct and/or indirect damage caused
by incorrect connections.
IMPORTANT! Before you perform the following
steps, make sure that the plug is disconnected
from the AC power supply.
TRANSPORT
Always use the packaging or case (when provi-
ded) when transporting the tool; this will protect
it from impact, dust and humidity which can
compromise normal operation.
HANDLING
Firmly grasp the handgrip (fig. 2) without using
the switch; keep the tool well away from your
body and after use place it down gently without
hitting the disc.
STARTING UP
When choosing where to use the power tool, the
following should be considered:
- that the area is not damp and is sheltered from
the elements.
- that the working area is sufficiently large and
free from obstacles.
- that the area is well lit.
- that the tool is used close to the interrupter
switch.
- that the power supply is equipped with an
earthing function in accordance with general
rules (only if the tool is in Class I, and equipped
with an earthing cable).
- that the room temperature is between 10° and
35°C.
- that the environment is not in a flammable/
explosive atmosphere.
Take out the machine and components and
visually check that they are perfectly intact; then
proceed to thoroughly clean them in order to
remove any protective oils from metal surfaces.
HEAD ASSEMBLY (Fig.A, 5)
If the head is supplied disassembled, follow the
indications shown in figure C.
CENTRAL HANDLING ASSEMBLY (Fig.A, 3)
Follow the instructions in figure D.
REAR PROTECTION ASSEMBLY (Fig.A, 20)
Follow the instructions in figure E. Fasten the
protection with the two screws in the position
indicated by the arrows.
SUCTION TUBE ASSEMBLY (Fig.A, 22)
Insert the tube on the dust suction connection
as shown in figure F.
Verify that the locking lugs are fitted correctly.
DISASSEMBLY OF REMOVABLE SECTOR (Fig.A, 16)
Extract the sector when using the machine near
edges.
Extract the component in the direction shown
in figure G.
Reassemble it by following the instructions in
reverse.
PAPER ASSEMBLY
Apply the paper by pressing it on the velcro
support on the dial (Fig. A pos.13) as shown
in figure H.
Use abrasive paper discs equipped with a Velcro
attachment.
PLATELET DISASSEMBLY (Fig.A, 13)
Wear protective gloves.
Proceed as shown in figure L, with one hand
block the pad and with the supplied Allen wrench
turn the shaft clockwise.
HEAD TILT ADJUSTMENT
Proceed as shown in figure L.
Remove the locking knobs and position the
head in the desired way, repositioning the knobs
themselves.
Position A indicated for working on vertical walls.
Position B indicated for ceilings.
