25
EN
Using the appliance
B
Temperature selection
• Each time a new programme is selected, the temperature recommended for the programme
appears on the temperature display.
• To reduce the temperature, press the temperature adjustment button again. The
temperature will gradually decrease. The temperature level lights will not come on when
you select the cold level.
NOTE : If the programme has not reached the heating
phase, you can change the temperature without switching
the machine to pause mode.
Spin speed selection
• Each time a new programme is selected, the recommended spin speed of the selected
programme is indicated by the spin speed indicator.
• To reduce the spin speed, press the spin speed control button. This speed will decrease gradually.
Then, depending on the product model, the "Rinse Hold" and "No Spin" options will appear on
the display. The temperature level lights will not come on when you select the “No Spin” function.
Rinse Hold
If you do not want to remove your laundry from the machine immediately after the end of the
programme, you can use the Rinse Hold function to keep your laundry in the final rinsing
water to prevent your clothes from becoming creased when the water no longer contains
any water. Press the "Start/Pause" button after this procedure if you wish to drain the water
without spinning. The programme will resume where it left off, it will empty out the water
and then end.
If you want to spin the laundry that is in the water, set the spin speed and press the "Start/
Pause" button. The programme will restart. The water will be drained, the laundry spun and
the programme will end.
NOTE : If the programme has not reached the rinse phase,
you can change the spin speed without switching the
machine to pause mode.
Secondary function selection
Select the required secondary functions before launching the programme. You can also select
or cancel the secondary functions adapted to the current programme without pressing the
Start/Pause button whilst the machine is in operation. In order to do so, the machine must be
in a phase before the secondary function that you intend to select or cancel. If the secondary
function cannot be selected or cancelled, the light for the corresponding secondary function
will flash 3 times to notify the user.
