Installation 5
0020149486_04 auroFLOW plus Installation and maintenance instructions
9
4.3
Information on the identification plate
The identification plate is mounted on the underside of the
product in the factory. The identification plate contains the
following information:
Information on the identi-
fication plate
Meaning
VPM D
For identification
P
max
Maximum solar output
m
Weight
V
s
prim
Solar circuit volume
V
s
sec
Cylinder charging circuit volume
T
max
prim
Solar circuit maximum temperat-
ure
T
max
sec
Cylinder charging circuit max-
imum temperature
P
max
prim
Solar circuit maximum operating
pressure
P
max
sec
Cylinder charging circuit max-
imum operating pressure
4.4
Product description
Abbreviation
Explanation
auroFLOW plus
For identification
VPM D
Solar charger
VPM 15 D
Solar system with basic module
of the VPM D solar charger.
Suitable for up to 6 collectors
(corresponds to approx. 15 m
2
collector surface)
VPM 30 D
Solar system with basic module
and expansion module of the
VPM D solar charger. Suitable
for up to 12 collectors (corres-
ponds to approx. 30 m
2
collector
surface)
4.5
Serial number
The article number of the product is taken from the serial
number. The seventh to sixteenth numbers constitute the
article number.
The serial number can be found on the identification plate.
The serial number may also be shown on the product's
display (
→
Operating instructions).
4.6
CE label
The CE label shows that the products comply with the basic
requirements of the applicable directives as stated on the
identification plate.
The declaration of conformity can be viewed at the manufac-
turer's site.
5
Installation
5.1
Storage conditions
▶
Store the product in a dry and dust-free room.
5.2
Unpacking the product
1.
Remove the strapping.
2.
Open the lid of the cardboard packaging.
3.
Take out the protective cardboard packaging, the en-
closure and the printed documents.
4.
Pull the carton up and off.
5.
Remove the product from the cardboard base.
–
Do not lift the product by its front casing.
6.
Remove the protective film from all parts of the product.
5.3
Scope of delivery for the basic module
Quantity
Description
1
Wall-mounting base
1
Basic module of the solar charging system
1
Cylinder temperature sensor
1
Enclosure containing printed documents
1
Bag with small parts for wall-mounting (bolts and
rawl plugs)
▶
Check that the scope of delivery is complete.
5.4
Scope of delivery for the expansion module
Quantity
Description
1
Wall-mounting base
1
Expansion module of the solar charging system
1
2. Solar pump
1
Pipe set for second solar pump
2
Connection pipes
1
Bag with small parts for wall-mounting (bolts and
rawl plugs)
▶
Check that the scope of delivery is complete.
5.5
Transporting the product
▶
Do not lift the product by its front casing.