Decommissioning 8
0020217119_01 aroCOLLECT Installation and maintenance instructions
21
7.2
Carrying out inspection and maintenance
work
Note
Due to the fluctuating outside temperature and
air humidity, it is normal for frost to form or for
the heat exchanger to freeze in the product. In
normal mode, the product automatically starts up
a thawing procedure.
▶
Check the product for dirt and, if required, clean it.
▶
Check the condensate discharge for blockages and, if
required, remove any dirt/blockages.
▶
Check the air inlet and outlet to ensure that the supply
and exhaust air is unobstructed and, if required, request
that the operator removes any vegetation or similar (min-
imum clearances). (
→
Page 9)
▶
Request that, in winter, the operator regularly ensures
that the product is free of snow on the intake and outlet
side.
7.3
Procuring spare parts
The original components of the product were also certified
by the manufacturer as part of the declaration of conformity.
If you use other, non-certified or unauthorised parts during
maintenance or repair work, this may void the conformity of
the product and it will therefore no longer comply with the
applicable standards.
We strongly recommend that you use original spare parts
from the manufacturer as this guarantees fault-free and safe
operation of the product. To receive information about the
available original spare parts, contact the contact address
provided on the reverse of these instructions.
▶
If you require spare parts for maintenance or repair
work, use only the spare parts that are permitted for the
product.
7.4
Cleaning the product
▶
When the casing is completely installed, clean the
product using a sponge and hot water (max. 70 °C) along
with commercially available household cleaners that do
not contain any abrasive elements in an aqueous solution
up to max. 2%. Do not use any sanitary cleaners that
contain chlorine or ammonia.
7.5
Cleaning the condensate discharge
3
2
1
1
Screws for the base
panel
2
Base panel
3
Condensate tray
1.
Remove the side sections of the casing (
→
Page 19)
and the front louvred grill (outlet side).
2.
Unscrew the screws
(1)
in the front base panel
(2)
and
remove the base panel.
3.
Carefully pull the condensate tray
(3)
forwards and out
from below the fan.
4.
Clean the connectors.
5.
Check that the outflow is free of obstructions. If
required, clean or replace this.
6.
Insert the condensate tray.
7.
Install the side casing and the cover. (
→
Page 19)
8
Decommissioning
8.1
Temporary decommissioning
▶
Disconnect the product from the power supply.
8.2
Permanently decommissioning
1.
Disconnect the product from the power supply.
2.
Drain the product. For this, use suitable collecting con-
tainers and only dispose of heat transfer media, such as
brine, at appropriate collection points.
3.
Dispose of or recycle the product and its components.
9
Customer service
10 Recycling and disposal
Disposing of the packaging
▶
Dispose of the packaging correctly.
▶
Observe all relevant regulations.
