6 Start-up
20
Installation and maintenance instructions aroCOLLECT 0020217119_01
7.
Anchor the cover to the product by turning each screw
through the slot in the retaining bracket in the frame.
6
Start-up
6.1
Start-up
1.
Ensure that the heat pump and system controller are
installed correctly.
2.
Switch the fuses on so that the heat pump and air/brine
collector(s) are supplied with power.
◁
As soon as the heat pump is supplied with power
during the initial start-up, the software initialisation
starts in the heat pump and in the system controller.
3.
Implement the other settings with the help of the install-
ation instructions for the heat pump and for the system
controller.
6.2
Handing the product over to the operator
▶
When you have finished the installation, affix the en-
closed sticker (which requests that the user reads the
instructions) to the front of the product in the operator's
language.
▶
Explain to the operator how the safety devices work and
where they are located.
▶
Inform the operator how to handle the product.
▶
In particular, draw attention to the safety information
which the operator must follow.
▶
Inform the operator of the necessity to have the product
maintained according to the specified intervals.
▶
Pass all of the instructions and documentation for the
product to the operator for safe-keeping.
7
Inspection and maintenance
7.1
Inspection and maintenance interval
Annual inspection/maintenance of the product by a compet-
ent person is a prerequisite for ensuring that the system is
constantly ready for operation, reliable and has a long ser-
vice life.
The inspection is intended to determine the actual condition
of the product and compare it with the target condition. This
is done by measuring, checking and observing.
Maintenance is required in order to eliminate any deviations
between the actual condition and the target condition. This is
normally done by cleaning, setting and, if necessary, repla-
cing individual components that are subject to wear.
Danger!
Risk of death from electric shock!
The air/brine collector has its own, separate
power supply and is not automatically de-en-
ergised when the heat pump is disconnected
from the power source.
▶
Always switch off the power supply for
each air/brine collector before carrying out
any inspection or maintenance work.
▶
Secure the power supply against being
switched on again.
Danger!
Risk of death from electric shock!
Due to electrical discharge processes, con-
tact with components inside the product may
cause an electric shock.
▶
Do not open the cover for the electronics
box in the product until three minutes after
the all-pole disconnection of the supply
voltage.
▶
Do not remove the louvred grill until at
least three minutes after the all-pole dis-
connection of the power supply. Never
try to take hold of the ventilator before the
three minutes have elapsed.
