Vaderstad Carrier CRX 425-625, Instructions Manual

Page: 12 / 48

Safety rules
12 01.05.2015 1
1.6 Moving the implement without connecting it to a trac-
tor
NOTE! If the implement must be moved without it being hitched to a tractor, it must be carried on
a machine trailer or truck flatbed!
The implement must be extended to working mode and lifted on and off the transport vehicle using
a crane. The implement must be positioned with its ends running along the length of the transport
vehicle.
1 Set the implement to working mode, see “2.5 Switching to working mode” on page 22 .
2 Set the working depth of the front tool so that the implement is standing parallel. Surface (A)
must be parallel to the base. Fit as many spacers as you can to the depth adjustment hydraulic
ram, see
“2.11 Setting disc working depth” on page 28 .
Figure 1.6
3 Unhitch the tractor from the implement.
4 Lift or lower the implement into position using a suitable lifting device. This device must be
attached to the lifting points on the centre section of the implement. These are indicated by the
decal , see “Figure 1.7 ” on page 13 or “4.16.1 Lifting with implement in work mode”
on page 42 .
! For information about the weight and dimensions of the implement, see “5.2 Technical data”
on page 46 .
5 Prevent the roller from rolling using chocks or similar.
6 Secure the implement using suitable lashing in accordance with applicable regulations. The
lashing must be secured on the implement at the positions indicated by this decal , see
“Figure 1.7 ” on page 13
.
! Always take into account national regulations in respect of transport dimensions, escort vehicle
requirements or similar.
A