Instructions and settings
22
01.05.2015 1
2.5
Switching to working mode
1 Lift the implement using the hydraulic arms. The implement must be lifted to a height that is
sufficient to allow folding to be done unhindered!
2 Pull the wing sections together using the hydraulic system.
3 Release the locking catches for both wing sections.
Figure 2.9
4 Fold out the wing sections using the hydraulic system.
!
Ensure that all folding cylinders are pressed out fully.
NOTE!
Hold the hydraulic lever in position for a further few seconds. This particularly applies to
CRX 525 and 625, where the correct pressure must be achieved in the accumulator tank.
Figure 2.10
5 Lower the implement to the ground.
+ 5 sek
