VADDIO PRODUCTIONVIEW HD MV, Installation And User Manual

Page: 31 / 36

ProductionVIEW HD MV
ProductionVIEW HD MV Manual - Document Number 342-0241 Rev G Page 31 of 36
Compliance and CE Declaration of Conformity
Compliance testing was performed to the following regulations:

FCC Part 15, Subpart B Class A

ICES-003, Issue 4: 2004 Class A

CISPR 22: 2009 Class A

European Standard EN 55103-1: 2009 Class A

European Standard EN 55103-2: 2009 Class A

EN 55022: 2006 + A1: 2007 (CISPR 22:2005/A1: 2005) Class A

EMC Directive 2004/108/EC Class A
FCC Part 15 Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15, Subpart
B, of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his/her own expense.
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must
accept any interference including interference that may cause undesired operation of the device.
Changes or modifications not expressly approved by Vaddio can affect emission compliance and could void the user’s
authority to operate this equipment.
ICES-003 Compliance
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio
Interference Regulations of the Canadian Department of Communications.
Le présent appareil numérique n’emet pas de bruits radioélectriques dépassant les limites applicables aux appareils
numeriques de la classe A préscrites dans le Règlement sur le brouillage radioélectrique édicte par le ministère des
Communications du Canada.
European Compliance
This product has been evaluated for Electromagnetic Compatibility under the EMC Directive for Emissions and Immunity and
meets the requirements for a Class A digital device. In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
Standard(s) To Which Conformity Is Declared:
EMC Directive 2004/108/EC
EN 55022: 2006 + A1: 2007 (CISPR 22: 2005/A1:2005)
Conducted and Radiated Emissions
EN 55103-1: 2009 Electromagnetic Compatibility
EN 55103-2: 2009; E2-Commercial and Light Industrial Immunity

EN 61000-4-2: 1995 + Amendments A1: 1998 + A2: 2001 Electrostatic Discharge

EN 61000-4-3: 2006 + A1: 2008 Radiated Immunity

EN 61000-4-4: 2004 + Corrigendum 2006 Electrical Fast Transients

EN 61000-4-5: 2006 Surge Immunity

EN 61000-4-6: 2009 Conducted Immunity

EN 61000-4-11: Second Edition: 2004 Voltage Dips, Interrupts and Fluctuations

Annex A of EN 55103-2: 2009
Note: For strict compliance to FCC, ICES-003 and CE radiated emissions standards, please use the provided Laird 100ohm,
¼” snap on rectangular ferrite on the DC cable of the power supply.