Edge Equipment Enclosures
. Edge Equipment Enclosures - Document Number 342-0026 Rev. A
Page 6 of 12
3) Preparing the Sides and Back for Assembly
a. Lay the sides on a flat clean surface with the holes facing up as shown below. Insert the
cams into the holes with the arrow facing the top and bottom edge of the side.
b. Finish the insertion of the cams on both sides and when finished, it should look like the image
below.
c. Lay the back on a smooth clean surface with the groove up as shown below. Insert vent into
back and install vent panel retention clips into predrilled locating holes to hold vent in place
as shown below.
d. The back panel with the installed vent panel and retention clips.
Cams x 6
