Edge Equipment Enclosures
. Edge Equipment Enclosures - Document Number 342-0026 Rev. A
Page 10 of 12
Once the enclosure is assembled, or if it is purchased assembled, the enclosure is mounted to the Edge
Videoconferencing cart using the following steps.
8)
Mounting the Edge Enclosure to the Edge Cart:
a. Remove the four (4) 10-32 x ¾” screws from the threaded T-nut on the bottom inside of the
enclosure.
b. Set the enclosure on the arms extending off the front of the cart.
c. Align the holes in the arms with the holes in the bottom of the enclosure.
d. Insert one screw in the front hole and turn it into the threaded T-nut but do not tighten it fully
to allow for easy alignment of the other three (3) screws.
e. Once all four (4) screws are threaded, tighten all the screws with a Phillips screw driver.
Thread four (4) 10-32 x ¾”
screws through extension arms
into the T-nuts in the bottom of
the enclosure. Tighten after all
screws are threaded.
Video monitor, camera,
camera mount, equipment
inside rack and Edge monitor
cart sold separately (simulated
video feed)
EE-9RU
EE- 9RU:
9-Space Rack
Mount Equipment Enclosure Shown
with Edge 799-1000-000 Monitor Cart
