ENGLISH
51
Anti-skid
When an opening or closing operation is interrupted by a command or
for the intervention of the photocell, the set-up time for the opposite
movement would be excessive, so the control unit operates the motors
only for the time necessary to recover the actually covered journey. This
could be not sufficient, particularly in the case of very heavy gates, as
because of the inertia at the inversion moment the gate runs an extra
space in the previous direction that the control unit is not able to take
into account.
If after an inversion the gate does not return exactly to the starting
position, it is possible to set an anti-skid time that is added to the time
calculated by the control unit in order to recover the inertia.
m
WARNING: if the function ASM is disabled, the reverse
manoeuvre lasts until the gate reaches the limit switch.
End of Programming
This menu allows to finish the programming (both default and
personalized) saving the modified data into memory.
no
further corrections to carry out: do not quit the programming.
Si
end of programming.
THE INSERTED DATA HAVE BEEN MEMORIZED: THE CONTROL
UNIT IS READY TO BE USED.
Enabling the ADI device
This menu makes it possible to enable operation of the device
connected to the ADI connector.
no
interface disabled, any signals will be ignored
Si
interface enabled
*
PLEASE NOTE:
selecting
Si
and pressing MENU accesses the
configuration menu for the device connected to the ADI connector.
This menu is managed by the device itself and is different for each
device. Please refer to the manual for the device.
If the
Si
option is selected, but no device is connected, the display will
show a series of dotted lines.
Exiting the ADI device configuration menu returns to the
i.ADi
option
Summary of Contents for FORTECO
Page 2: ......
