Remove the 3 screws (12d), plate (12c), spring (12b) and circlip (10c);
Remove the 3 screws (21) keeping the washers, remove the mechanism unit
(20a) and the coupling pin (14);
Move the jaw (13) downwards and remove it (see chapter 7 DISPOSAL, page
30/32);
Place the new jaw (13) in to position, fit the circlip (10c), spring (12b) and plate
(12c);
Tighten the screws (12d) to torque M = 50 Nm using Loctite 243;
Fit the coupling pin (14) and the mechanism unit (20a) (see point 3 in chapter
5.2 REPLACEMENT OF THE MECHANISM UNIT AND THE COUPLING PIN, page
22/32).
1)
2)
3)
4)
5)
6)
ATTENTION: Make sure that the coupling is closed, ie. the coupling pin
(14) is down.
5.4 REPLACEMENT OF THE COUPLING JAW
Wear working gloves and heavy working shoes
14
20a
12b
10c
12d
12c
13
V . O
RLA
ND
I
REV. 00
CHAP. 5
PAG.
24/32
DRAWBAR COUPLING E 40
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
Summary of Contents for E 40
Page 32: ......
