UVP biodoc-it 2, Installation And User Instructions Manual

Page: 17 / 22

BioDoc-It
2
Imaging System 17
81-0358-01 Rev E
Save
date of image capture and
“hh-mm-ss” being the time of
image capture.
NOTE : To manually change the file name when saving an
image, select Prompt for Location under the Saving tab
in Settings prior to saving. Then, each time the Save
button is pressed, the user will be prompted to select a file
save location and can enter a custom file name.
NOTE: If Save Selected & Original Formats is selected
in the Settings menu (described earlier in this manual) and
the Save button is pressed, both the selected and original
formats will be saved. However, if the Save Burned button
is pressed, only the selected format will be saved.
Print
Press the Print button to print the current image on the
default printer. If a default printer is not installed, pressing
the
Print button will place the print request in queue.
Histogram
See the Histogram section in the Acquisition portion of
this manual for information on using the histogram in
Gallery view.
Time Stamp
To add a date stamp to the captured image, press the
Time Stamp button, then press the slider until the check
mark appears. This will add mmm/dd/yyyy hh:mm:ss to
the bottom right corner of the image.
NOTE: The time stamp is not saved to the image unless
Save Burned is selected (as described earlier in this
manual).
Pseudocolor and Invert
Press the Pseudocolor button to access a variety of
Pseudocolor options for captured images. Pseudocolor
options include
in vivo , oversaturation (shows yellow to
indicate mild overexposure and red to indicate extreme
overexposure),
yellow , red , green and blue . Press the
appropriate radio button to select the desired pseudocolor.
Press the Invert button to access image inversion
selection. Under Invert , touch the slider until the check
mark appears to activate image inversion.
NOTE: Pseudocolors and image inversion are not saved to
the image unless Save Burned is selected (as described
earlier in this manual).
Minimize and Close
Press the Minimize
(“
_
”) button in the upper-right corner of
the screen to minimize VisionWorks touch .
Press the Close
(“
X
”) button in the upper-right corner of
the screen to close VisionWorks touch . If any unsaved
images are open prior to closing VisionWorks touch , the
user will be prompted to choose one of the following:
1. Save the current image
2. Not save the current image
3. Cancel closing the software
4. Save none of the images