Manual v1.7 – Nov 2017 © Utilivista Ltd. 2017 14
3.
Place repeaters where there are gaps in the network to ensure every node and node/receiver
has at least one path to the
Entranet
.
The exact position of all nodes, node/repeaters and repeaters will always need to be fine-tuned in-
situ using the range indicators. Detailed instructions for the positioning and fixing of devices can
found in Section 3 and Appendix A.
5.1.2. - Setting-Up the C2i Network
Step 1: Initial Setup
•
Install the
Entranet
gateway/receiver in a suitable location.
•
Access the local configuration pages (
Settings/Network/Allow New Nodes
) and set the
Entranet
to allow new nodes.
Step 2: Setup the nodes and repeaters
See
EnCompass
868
Manual, Section 6 and 7
5.2 – Adding a new
EnCompass
to the network
1.
Go to
Settings
and then
Network
2.
Set
Allow
New
Nodes
to
Yes
3.
Click
Save and Apply
(This setting will last until 00:00 at the end of the day.)
4.
Use a magnet to put the
EnCompass
into Learn Mode. (See
EnCompass
868
Manual)
If successful then after a refresh of the menu you should see the node serial number listed in the menu.
