PROGRAMMING THE CONTROLLER PARAMETERS
3. Function F3: Relay timeout
Enter programming mode. Display function
F3
using and keys, then validate with the key
The display then indicates the number and the lock time release of door 1: for example
103
means
that the relay of door 1 is controlled for three seconds.
201
means that the relay of door 2 is
controlled for one second.
To move on to the lock release time of the other door, use and keys.
After choosing a door, press the key: The number of the door remains displayed while the
release time flashes. To change the value, use the and keys
To validate the release time use the key: The display indicates
F3
again.
CAUTION: The lock release time can be programmed from 01 to 99 seconds. When timeout 00
is programmed, the relay of the door operates in bi-stable mode. This mode functions only with the
radio frequency receiver. In this mode, in the event of a power supply failure, the relay of the
door will be deactivated. When the power supply is restored, the relay returns to the status it had
before the power failure.
4. Function F4: copy on back-up memory
Enter programming mode. To save the unit memory, connect the backup memory to its location.
Display function
F4
using and keys then validate using the key. If the memory is a 2KS
(500 keys version), a message
DIF
advise that only the 500 first keys will be copied. The display
indicates
1-2
which means a copy of the main memory to the backup memory ( SAVE DATA).
You can switch between
1-2
and
2-1
using and keys.
The display
2-1
means a copy of the backup memory to the main memory (RESTORE DATA)
During copying, the display will indicate
COP
and at the end of the copy the readout indicates
F4
if
the copy has been made correctly or
err
if an error has been detected in copying.
CAUTION : During copying, it is impossible to control the door: the keys and remote controls
are not read and the pushbuttons do not operate.
5. Function F5: test de level of RF interference
Enter programming mode. Display function
F5
using and keys then validate using the
key.
The display indicates
---
during the analysis. The analysis will last 30 seconds. At the end of the
analysis, the display indicates a value between 0 and 99 corresponding to the level of saturation of
the radio frequency receiver.
If the readout indicates a figure between
0 and 30: it means very good radio reception
30 and 50: it means good reception
50 and 75: it means poor reception
75 and 100: it means bad reception condition
CAUTION : During the analysis, control of the doors is impossible: the keys and remote controls
are not read and the pushbuttons do not operate.
17
50-000-611 DOC TRANSIT GB FDI
C
