57
DS1083-046A
8.1.
ACCESS TO PROGRAMMING PROCEDURE
Access programming mode as follows to program a new calling module or editing exiting programming:
Key in
99999
on the keypad. The page shown by the side will appear.
Enter the password (default password:
1000
) and press
OK
to con
fi
rm.
The page by the side will appear if the password is not correct.
Wait for approximately 3 seconds before attempting to enter the password
again.
IMPORTANT
: If you set a new password instead of the default one and loose
it, ask Urmet Customer Care for a temporary password to access programming
mode, read the lost password and set a new one.
To obtain a temporary password:
Enter the sequence,
X OK 9 6 3
with the calling module in stand-by mode.
A six-digit number (
SERVICE CODE
) which is different each time will
appear on the display.
Contact Urmet Customer Care and read the SERVICE CODE. The Urmet
operator will supply a
temporary password (PT)
.
Use the PT to access calling module con
fi
guration and read the lost
password. The old password will remain valid for accessing con
fi
guration
until it is changed.
IMPORTANT:
The PT you will be given can be used to access con
fi
guration
until the calling module is reset again or until the sequence shown in step 1 is
entered again.
1.
2.
3.
Summary of Contents for ELEKTA STEEL
Page 91: ...91 DS1083 046A...
