VIDOORA Installation and Operating Instructions
Page | 9
9Connect
power
supply
Connect the door station to the power supply.
I
MPORTANT
:
Observe the connections and voltage ranges as shown in the table.
Figure 13: Power supply
Connection to the upper terminal
~ (+)
Connection to the lower terminal
~ (-)
Voltage ranges for DC voltage
12 V DC
Voltage ranges for AC voltage
8 - 12 V AC, 50 Hz
Table 3: Power supply
10BConfigure
door
station
Configure the door station in the app CallMe
app (see chapter 6).
11Check and adjust
angle
of
view
Check that the integrated camera correctly detects
people in the entrance area.
Good to know:
If the result is not satisfactory, you can
change the viewing area by using the mounting
brackets, which are optionally available.
Last but not least:
Now remove the protective film. This is not necessary for daily operation, as the surface of the
door station is protected against everyday weather influences.
3.2
Mounting on flush-mounted box
Open housing
•
Loosen the two screws on the bottom of the
housing.
Keep the screws and the top part safe until you
need the parts again.
Figure 14: Bottom side of housing
•
Carefully unfold the underside (see the following
figure, point 1).
•
Carefully pull the upper part of the housing upwards
(see following figure).
Figure 15: Removing the upper part of the housing
