VIDOORA Installation and Operating Instructions
Page | 6
Sabotage contact
On the board of the VIDOORA door station there is a
sabotage contact which sends an alarm message as a
push message to the CallMe App as soon as a
manipulation attempt is made on the VIDOORA. The
alarm messages can be called up in the alarm history
of the CallMe App.
Figure 6: Alarm history
SD card
•
The SD card slot is located at the top edge of the door
station on the circuit board at the rear.
•
The micro SD card is formatted in low-level format
•
The Micro SD card contains the firmware of the
VIDOORA WLAN door station.
IMPORTANT:
Please do not remove the Micro SD card!
Functions of the programming (reset) button
•
Status changes are made via the programming
button.
•
When the door station is started for the first time,
the programming mode is started automatically.
•
If you wish to configure the door station
differently, reset it or restart it, you must press
the programming button.
Figure 7: Position programming
button
Desired change
Programming button Action
Reset to factory settings
Press 8 times
Configure
Press 8 times
Switch on programming mode
Operate 4 times
Restart without loss of settings
Press and hold for more than 10 seconds
Good to know:
You can operate the programming button at any time without opening the door station.
To do this, loosen the left-hand screw and simply push a wire with a diameter of about 2 millimetres (e.g. a bent
paper clip) through the opening onto the programming button.
