urmet domus 1067/024, Installation Manual

Page: 64 / 120

DS1067-063D
64
LBT20064
Detail
Terminal /
Detail
Description
A
+PS Input +14.4 V power supply (at the positive pole of the power supply)
-PS Input power supply (at the negative pole of the power supply)
B
+BT Connection positive pole of the back-up battery
-BT Connection negative pole of the back-up battery
C
+
BUS -
Power supply 13.8 Vdc ─ limited to 1.1A for devices connected via bus
-
+D
BUS - Data transmission/reception
D
D
+V2 Power to detectors connected to control panel (13.8 Vdc limited to 750 mA).
The mother board has two pairs of power supply terminals.
-V2
IN1
Alarm input n. 1
IN2 Alarm input n. 2
IN3 Alarm input n. 3
IN4 Alarm input n. 4
IN5 Alarm input n. 5
IN6 Alarm input n. 6
IN7 Alarm input n. 7
IN8 Alarm input n. 8
SAB Input 24h (for system self-protection).
It must always be BALANCED and closed with a
2,7 kΩ balancing resistor.
E
+SR Power supply (14.4 Vdc limited to 200 mA) - for recharging the batteries of the self-
powered devices (ex. sirens). It is possible to connect up to 2 self-powered sirens.
IMPORTANT! In case of blackout, +SR supplies no voltage, therefore it must be used only
to connect self-powered devices. The self-powered devices must have a positive anti-
return diode (all self-powered Urmet actuators are equipped with one).
+V1
Power supply for output actuators (13.8 Vdc limited to 750 mA)
-V1
NC1
Relay output 1
– contact normally closed
NO1 Relay output 1
– contact normally open
C1 Relay output 1
– common (max. 1 A - 24 Vdc)
NC2 Relay output 2
– contact normally closed
NO2 Relay output 2
– contact normally open
C2 Relay output 2
– common (max. 1 A - 24 Vdc)
U3 Electric output 3 (current protected max. 100 mA)
U4 Electric output 4 (current protected max. 10 mA)
U5 Electric output 5 (current protected max. 10 mA)
U6 Electric output 6 (current protected max. 10 mA)
F
J6 Connector for 1067/002A PSTN communicator
G RUN Green LED to signal functioning of the control panel (see paragraph 6.1.1 )
H POWER Green LED to signal presence of the 230 V mains power supply
I
J11 Connector of the USB and Web server interface
L J5
M
DIP
SWITCH Dip-switch to reset parameter
– see
functions associated with the dip-switches (Table 7)
(normally they must be left OFF)
N J4 Connector of the vocal synthesis board
P
TAMPER Connector for connection of the control panel tamper
JP7 Jumper for the exclusion of the control panel tamper (Jumper inserted = tamper excluded)
Q
JP3 Jumper configuration output U3
JP4 Jumper configuration output U4
JP5 Jumper configuration output U5
JP6 Jumper configuration output U6
R SERVICE Connector for connecting the service keypad
S J7 Connector for 1067/458 GSM module (with insertion on the rear side of the mother board)