Step 2.1 Roost Sub Assembly
Round-Top Walk-In Coop
Copyright ® All Rights Reserved
Urban Coop Company
TM
Find your inner farmer
TM
Œ
Using Brown T25 screws, assemble panels of the Roost Sub Assembly as shown in the figure below. We try to pre-drill all the holes :) many of
which are blind going up from the bottom into the upper rails to hide the screw heads.
indicate minimum number of screws at joints for
X’s
assembly to be strong, more is okay. See Fig
Œ
for how sides join to back. Making bottom edge flush. Top will fall correctly if bottom is flush.
Using Green T-20 screws, attach 3 G11 eaves (centering middle board first and then placing left and right ones next) making back beveled edge
of eave boards flush with top beveled edge of G10’s. See Fig
. When centered, ends will overhang by about a 1/2 inch.
G10L
G10ML
G10MR
G10R
G2
G3
G1
G3
G1
Roost Side Sub Assembly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
G9 Panels
Screw Pattern On
This End Same As
Other End
Bottoms Flush
G2
X
X
X X
Back G10 & G9
Ends G1, G2 & G3
Fig
Œ
Screw Back Into
Sides With Sides
Overlapping
Back
Beveled Top Edge Slants
Down and Out
3X G11 Eave Boards
G11
G10
Fig
Ends of G11 eaves when
centered will stick out
beyond ends by
about 1/2 inch.
Summary of Contents for Round-Top Chicken Coop Walk-In
