Urban Coop Company Round-Top Chicken Coop Walk-In, Assembly Instructions Manual

Page: 18 / 41

58"
Stand Up Run
Area
Front Door
(Could Be On Other Side) Step 1.6 Foot Print Squaring
Round-Top Walk-In Coop
Copyright ® All Rights Reserved
Urban Coop Company
TM
Find your inner farmer
F B
B
C
C
Recommended North
Aerial View Of What You Should Have
Assembled So Far...
Run Egg Box Side Wall
Run Roost Side Wall
TM
ü
99 1/2"
Drive 12” Stakes Into
Ground After Squaring
Run & Making Sure
Door Opening Is
27 1/2 Inches Inside Opening
=
Œ
Observe drawing and make sure that what you have done so far matches up to
illustration, 58” wide and 99 1/2” long, off no more than 1/4”.

Next, using a measuring tape, measure the diagonals of the lower run until each corner-
to-corner measurement is equal. Hold tape level each time and pull taught. Rack as
needed to make 90° corners which will happen when corner to corner is equal.
Ž
Using provided level, check all sides placing the level in different spots and level the
coop in all directions vertical and horizontal and make sure that it is not rocking. Some
settling will occur and it is okay, but this is the time to get it the best you can.

Referencing the footprint at the front of these instructions, position the coop on your site
area where you want it as this portion won’t be moved again. Recommended North is
based on the Roost being Protected from wind.

Finally, see note

in illustration and make sure mid section long walls and front wall is
straight by moving back and forth until wall is straight along string, just touching it.
‘
Make sure the A2 Lower Front Panels have 27 1/2” between them up and down and
then using a hammer, drive the 12” provided stakes down through the holes in A2 bottoms
into ground so as to keep door frame properly separated. Make sure corners are square.
27 1/2"
A2L A2R
D Back Run Wall

Pull string
taught along
both long
sides and
front and
make sure
walls are
straight.
Push or pull
in or out as
required.
90°
90°
90°
90°
Critical Step!