Step 1.2 Lower Run Roost Wall
Round-Top Walk-In Coop
Copyright ® All Rights Reserved
Urban Coop Company
TM
Find your inner farmer
TM
Œ
Using the brown T25 screws, screw the upper rail of CL1 Apron Panel C2L Roost Access Door Assembly concealing the screws on the
underside of the parts. Make sure all edges are flush. Use at least three screws to join parts.
Repeat procedure in step 1 for the C1R and C2R panels.
Ž
Screw C5 to top of C4 making flush on all edges. Pre-Installed brackets on the C4 C5 strut are on back side.
Attach the C1/C2 Left assembly to the C4/C5 Strut assembly making top edges flush. Repeat for the C1/C2 Right side too.
Attach rear lower D Run Back Wall Assembly to the C Run Roost Wall lower assembly making sure bottom edges of C1 are flush with the
seam of the two back D panels and the D wall assembly mates flush on the outside of the C wall assembly.
‘
Attach A2R side door panel onto front outer edge of the C Wall Assembly where bottom of C1R is 25” from bottom of A2R.
*B Egg Box Run Wall Assembly
In Prior Step Omitted
D Run Lower Back W
all Assembly
C Run Lower Roost W
all Assembly
Lines up. Bottom
of C1 is 25” off
bottom of lower D panel.
25 inches
Standing Inside Run Looking at Roost Wall
Wire Faces In...
Summary of Contents for Round-Top Chicken Coop Walk-In
