Urban Coop Company Round-Top Chicken Coop Walk-In, Assembly Instructions Manual

Page: 19 / 41

Step 1.7 Run Roof Frame
Round-Top Walk-In Coop
Copyright ® All Rights Reserved
Urban Coop Company
TM
Find your inner farmer
TM
Œ
Insert E1 Mid Arc into E4 support brackets that were installed in prior step. Using H2 Gold T-25 5” long screws, drive two screws in each
outter run wall B & C such that the screws drive through the B1 & C3 upper panels and into the laminated end of the E1 mid arc. Screws will be
driven at an angle and should drive into the middle of E1 in an upper and lower pattern. See Fig
Œ

Insert front end set of E2 Roof supports so that the notched corbel ends stick out beyond A4 Front Arc and the square back ends fit into pockets
on E1 Mid Support. Fit will vary but should be snug. Drive 1 T25 Brown screw from inside of back side of E1 pockets so the screw drives through
E1 and into E2 ends. See Fig

Ž
Repeat process in step

for back set of E2 Roof Supports that hook into D2 Back Arc. Secure back side of this set of Roof Supports by toe
screwing a Brown T25 screw at an angle from the back side of E1 Mid Arc so that the screw drives into E2 holding it secure to E1. Fig

Note:
These screws are mainly used to hold the roof into place while the eaves and metal are installed which will do most of the work to keep the
roof attached. So make it look pretty, and know that the work of keeping things strong happen in next steps.
4X E2 Roof Supports
E4 Bracket
E1 Mid-Arc
Fig
Œ
See-Thru View
Looking Outside to Inside
End View
E1 Mid Arc
E4 Bracket
Beveled Top
Edge of Run
Side Walls
Gold T25
Long Screws
Walls Of Run Built So Far
Are Omitted For Simplicity
Fig

First
Screw
2nd
Screw
E2 E2
E1