Upright X26N, Service & Parts Manual

Page: 25 / 100

9 M
AINTENANCE
Page 2- 17
B
A T T E R Y
M
A I N T E N A N C E
W A R N I N G
!
!
Hazard of explosive gas mixture. Keep sparks, flame, and smoking material away from batteries.
Always wear safety glasses when working near batteries.
Battery fluid is highly corrosive. Thoroughly rinse away any spilled fluid with clean water.
Always replace batteries with UpRight batteries or manufacturer approved replacements weighing
30 kg (
66 lbs. ) each.
• Check the battery fluid level daily, especially if the machine is being used in a warm, dry climate.
• If electrolyte level is lower than 10 mm (
3
/
8
in.) above the plates add distilled water only. DO NOT use
tap water with high mineral content, as it will shorten battery life.
• Inspect the battery regularly for signs of cracks in the case, electrolyte leakage and corrosion of the
terminals.
• Inspect cables regularly for worn spots or breaks in the insulation and for broken cable terminals.
• Keep the terminals and tops of the batteries clean.
• Refer to the Service Manual to extend battery life and for complete service instructions.
B
A T T E R Y
C
H A R G I N G
Figure 13: Battery Charger
Charge the batteries at the end of each work shift or sooner if the
batteries have been discharged.
W A R N I N G
!
!
Charge the batteries in a well ventilated area.
Do not charge the batteries when the machine is near a source of sparks
or flames.
Permanent damage to the batteries will result if the batteries are not
immediately recharged after discharging.
Never leave the battery charger operating for more than two days.
Never disconnect the cables from the batteries when the charger is
operating.
Keep the charger dry.
1. Check the battery fluid level. If the battery fluid level is lower than
10 mm (
3
/
8
in. ) above the plates add distilled water only.
2. Connect an appropriate extension cord to the charger outlet plug in
the left module door. Plug the extension cord into a properly grounded
outlet of proper voltage and frequency.
3. The charger turns on automatically after a short delay. The LED charge indicator will illuminate. After
completion of the charge cycle the LED will blink, indicating that the charger is in a continuing
maintenance mode. DO NOT leave the charger plugged in for more than 48 hours, as permanent
damage to the batteries may occur.
NOTE: The battery charger circuit must be used with a GFI (Ground Fault Interrupt) outlet.
NOTE: DO NOT operate the machine while the charger is plugged in.
1. Battery Charger
2. Charge Indicator
3. Charger Plug
4. Batteries
4
1
2
3