Upright ab62, Service And Parts Manual

Page: 17 / 146

AB62 Work Platform - European 2-7
M
ACHINE
P
REPARATION
& O
PERATION
Section
2.5
4. When ready to move the machine, remove the
chocks. Tow or winch into position and replace
chocks.
5. Engage all four drive hubs by returning the center
caps to their original orientation.
Figure 2-6: Disengaging Drive Hub
2.5 T
RANSPORTATION
By Truck or Trailer
1. Insure that boom is fully lowered and retracted.
2. Raise the jib before the machine starts up or
down ramp to avoid platform contacting ground.
3. Maneuver the machine onto the bed of truck/
trailer.
4. When winching, follow instructions for emergency
towing on page 2-6. Attach winch cable to front
tie down lugs.
5. After winching, ensure that wheels are chocked.
NOTE: When hubs are disengaged, the brakes
are ineffective. The machine will roll freely.
6. Secure the machine to the transport vehicle using
chains/straps of adequate load capacity (refer to
specifications on page 1-2) attached to chassis
tie down lugs (See Figure 2-7).
7. Place a wooden block (20cm x 10cm x 75cm)
7.5” x 4” x 28” under platform support braces as
shown (See Figure 2-7).
8. Attach ratchet strap under platform floor grating,
over support braces (See Figure 2-7). Tighten
securely; do not overtighten.
Figure 2-7: Securing the Machine for Transportation
After Use Each Day
1. Ensure that the platform is fully lowered.
2. Park the machine on level ground, preferably
under cover, secure against vandals, children or
unauthorized operation.
3. Turn the upper key switch to OFF, the lower key
switch to PLATFORM, and remove all keys to pre-
vent unauthorized operation.
C A U T I O N
! !
DO NOT move the machine faster than 5 km/h
(3 mph). Faster speeds will damage drive com-
ponents and void warranty.
C A U T I O N
! !
Do not winch machine faster than 5 km/h (3
mph).
Drive Hub
Center Cap
W A R N I N G
! !
NEVER elevate the machine while on a truck or
trailer.
Chassis Tie Down
Lifting Lug (typ.)
Wooden Block
20 cm x 10 cm x 75 cm
(8” x 4” x 28”)