www.uponor-usa.com • www.uponor.ca
12
Uponor Climate Co˘ntrol™ Zoning System Installation Guide
13
Register Room Thermostats
An example of registering a thermostat: one thermostat
controls two actuators that connect channels 02 and 03.
1. Push the Test button.
�
The Test button LED lights up
.
2. Push channel button 02.
3. Push channel button 03.
�
The LEDs of channels 02 and 03 will flash
.
4. Using a small pointed tip, press the thermostat’s
registration button, located on the bottom of the
thermostat, for at least five seconds.
For Thermostat Display T-75:
• The thermostat displays two lines.
• Release the button when the temperature reappears.
5. LED will flash and turn solid, indicating a
successful link.
Repeat the same sequence for all thermostats.
�
The Test LED switches off
.
LED
LED Status
LED on
LED flash
LED off
Cancelling the Registration of a Channel
1. Press the Test button.
�
The Test and channel LEDs with registered
thermostats light up
.
2. To cancel, press the channel button for 10 seconds.
�
The LED of the cancelled channel flashes
for two
seconds, then switches off
.
3. Press the Test button to exit registration mode.
�
The Test LED switches off
.
Caution:
To register a different thermostat
to a channel, cancel the registration of the
existing thermostat prior to linking to new
thermostats. Then repeat the steps as outlined
in the
Register Room Thermostats
section
on this page.
5 seconds
5
5 seconds
5
Determining the Thermostat Location
• On an indoor wall
• 5' from the floor
• Away from any source of moisture
• Away from any source of heat
• Away from direct sunlight
Mounting the Thermostat
There are two ways to mount a thermostat:
• Direct mounting (using screws or adhesive strips)
• Thermostat mounting kit (includes table stand,
wall bracket, adhesive strips, screws and batteries)
Mounting Using Screws or Brackets
1. Screws should protrude from the wall.
2. Hang the thermostat on the screws.
3. When using the mounting kit bracket, mount
bracket to the wall, then hang thermostat
on bracket.
Mounting Using Adhesive Strips
1. Use the double-sided adhesive strip to fix the
thermostat on a smooth wall, such as glazed
ceramic tiles.
5 feet
Mounting Directly to the Wall
Mounting to the Bracket