© UPLIFT Desk
• 1-800-349-3839 • 1-512-614-3152 • [email protected] • upliftdesk.com
9
Step 16
Flip the Return assembly right-side up, and rest it
CAREFULLY onto the Support brackets (H8) and
Corner end (C5).
Note:
If you are assembling the Right-return configu
-
ration, The Corner end (C5) will not be sticking out.
One person should hold the Return assembly in place
to avoid stressing the Support brackets, and to keep
it still while you lay underneath the desk to finish as
-
sembly.
Step 17
Slide the Upper crossbars already inside the Return
desktop assembly back into the Corner end (C5) of
the Main Desktop assembly.
Screw two (2) #10x5/8’’ Wood screws (H3a) into the
last two holes of each Support bracket (H8).
At this point, if you are assembling the Left-return
configuration, Use one (1) of the screws used in Step
10 to attach Corner end (C5) to the Return Desktop.
*
Step 18
Insert and tighten the remaining eight (8) M6x10
Screws (H2) into the Frame and Corner ends, to se-
cure the Crossbars in place. Make sure all Set screws
make contact with the Upper crossbars.
Step 19
Plug the Power cable, Leg cables, and Keypad cable
into the Control box (C10).
