© UPLIFT Desk
• 1-800-349-3839 • 1-512-614-3152 • [email protected] • upliftdesk.com
7
Step 9
Line up the Frame assembly (from Step 6.1 or 6.2)
with the pre-drilled holes on the Main desktop.
Note:
Lift the frame, DO NOT SLIDE IT, when lining
up the frame for placement. Sliding the Frame may
scratch the underside of your desktop, or peel off the
Adhesive pads.
Step 10
Choose which screw should attach frame to desktop.
If your pre-drilled desktop does not have metal thread-
ed inserts, use the #10x5/8’’ Wood screws (H3a).
If your pre-drilled desktop
does
have metal threaded
inserts, use the #10-24x5/8’’ Machine screws (H3b).
After ensuring that the desk frame is properly posi-
tioned, attach the frame to the Main desktop using
eight (8) of the chosen screws (H3a or H3b). Make
sure all screws are started before fully tightening
them.
If you are assembling a Left-return desk, do NOT
put a screw into the hole on the Corner end (C5).
You will do this later, after the desk is right-side up.
*
or
H3 b
H3 a
C3
C4
C5
C9
H4a
H7
C6
H1
H2
H3
H5
H4b
H6
C7
C3
C4
C5
C9
H4a
H7
C6
H1
H2
H3
H5
H4b
H6
C7
Step 11
Secure the Upper crossbars at both ends of the Frame
Assembly using eight (8) M6x10 Screws (H2), four (4)
per side. Tighten using the 4mm Allen wrench (H5).
The Upper crossbars do not need to be perfectly cen-
tered, but make sure that all eight Set screws make
contact with the Crossbars.
H2
H2
*
C5
