© UPLIFT Desk
• 1-800-349-3839 • 1-512-614-3152 • [email protected] • upliftdesk.com
11
When moving the desk, if casters are not installed, use a two-person lift and lift the desk so that it can be
moved without dragging. Dragging the desk may cause the frame and screws to pull loose from the desktop.
When moving the desk, DO NOT lift the desk by the desktop alone. Support both the frame and the desk-
top equally. Favoring one over the other can stress the fasteners connecting the desk frame to the desktop.
Lower the desk completely before moving it.
Choose a placement for the desk that’s a safe distance from window frames, radiators, furniture, etc., so that
people do not get stuck or trapped by the desk, and nothing obstructs the desk from rising or lowering.
Ensure adequate cord clearance before using the desk. Connect desk’s power cord to the 120v outlet to
make the desk ready for use.
Do not place any objects underneath the desk that are taller than 21’’.
DESK PLACEMENT
KEYPAD LOCK
The keypad can be locked to prevent accidental activation or movement of the desk.
To lock:
Press and hold “M” button until display changes to “LOC”
To unlock:
Press and hold “M” button until display changes to numeric height setting.
NOTE:
If a power outage occurs, the program will automatically return to the unlocked setting.
MEMORY SETTINGS
Save up to four commonly used desk heights and recall them quickly.
l. Use the UP or DOWN button to move the desk to the desired height.
2. Press the “M” button.
3. Press the “1, 2, 3, or 4” button to assign the current height to a number on the keypad.
4. To recall any of those heights, press the numbered button to bring desk to assigned height.
These UPLIFT Desk programming instructions are compatible only with the Advanced 1-Touch Digital
Memory Keypad and control boxes with the following numbers located on the silver sticker:
Three-leg frame: 99.046.14.0070
HEIGHT CALIBRATION
Make sure the numeric display matches the actual height of the desktop in its lowest position.
1. Hold the DOWN button on the Keypad until the desk reaches its lowest height, then release.
2. Measure the height from the floor to the underside of the desktop. If the displayed height does
not match your measurement, follow the next steps.
3.
Hold the DOWN button again until the LED display reads “RST”
4. Press the “M” button until the numeric display begins flashing.
5. Press the UP or DOWN button to set desk to the measured height.
6. Once display changes back to “RST”, Hold the DOWN button until the desktop lowers slightly,
then rises slightly and the display changes back to the numeric height setting, then release.
*Note:
“RST” will look like
“ASr” on the display
PROGRAMMING (Advanced 1-touch digital keypad only)
C3
C4
C5
C9
H4a
H7
C6
H1
H2
H3
H5
H4b
H6
C7
