26
Step 7: Testing the System
It is recommended to test all system components (kit-supplied and
additional) to ensure correct operation.
Performing a Keyfob Test
Test keyfobs by pressing the arming / disarming buttons to observe whether
the respective chimes are heard, and whether the control panel display
indicates arming/disarming.
Performing a Walk Test for Detectors
For PIR and magnetic door / window contact detectors, perform a walk test.
This entails arming the system, then walking through all PIR-protected
zones and also opening all magnetic contact-protected doors and windows
– with the intent of triggering the alarms, to ensure the components are
working correctly.
To perform a walk test:
1.
At the control panel, press
.
2.
Enter the engineer code (default is
1111
) or master code (default is
1234
).
3.
Enter
7
> 0
>
6
; all registered PIR and magnetic door / window
contact detectors display chronologically, according to when
registered. Scroll using
to view them all.
NOTE:
Before doing the walk test, keep in mind that a PIR
detector needs 90 seconds for warming up for after battery
installation.
4.
Make sure nobody is in the armed zones when you initiate the
walk test, otherwise it may take up to 4 minutes to reset the PIRs.
5.
Walk through all armed zones to trigger alarms for each PIR
detector, and also open the doors/windows for each magnetic
contact detector. When the system receives a transmission signal
from a detector, it will no longer display on the control panel
(indicating the detector is working correctly).
Summary of Contents for SecuPlace WiFi
Page 21: ...21 OR ...
Page 22: ...22 ...
